Reasons for failure: (1) The oil level of the hydraulic gear pump oil tank is too low;
Remedy: add hydraulic oil
Reasons for failure: (2) Hydraulic oil is not used according to the season;
Elimination method: usually 46# hydraulic oil (or 68#) is used without special replacement, and 32# is considered when the northern part is extremely cold in winter.
Reasons for failure: (3) The oil inlet pipe is seriously blocked by dirt;
Elimination method: remove the foreign body in the tube
The cause of the failure: (4) The oil seal of the driving gear of the oil pump is damaged, and the air enters the hydraulic system;
Remedy: Replace the aging or damaged oil seal and O-ring seal
Reasons for failure: (5) Oil pump inlet and outlet joints or elbow joint "O" seals are damaged, elbow joint fastening bolts or inlet and outlet pipe nuts are not tightened, and air enters the hydraulic system;
Reasons for failure: (6) Hydraulic gear pump oil pump internal leakage and aging seal ring;
Remedy: Replace the O-ring seal, tighten the bolt or nut at the joint
The cause of the failure: (7) The end face of the hydraulic gear pump or the end face of the main and driven gear shaft sleeves are worn or scratched, and the unevenness of the end faces of the two shaft sleeves is out of tolerance;
Remedy: replace the sealing ring
